Quick Verdict
Removing a washer and dryer set is one of the most predictable appliance haul jobs in Oregon. Both units are designed for easy disconnect — the washer has standard hot and cold hoses and a 120V plug (or a 240V plug for combo units), and the dryer has either a 240V outlet and a vent hose, or a gas line and a vent hose. A reputable hauler charges a pair-rate that is cheaper than two single-item haul fees. Scrap value is real, and most Oregon crews route these through a metal recycler.
If you are upgrading to a new laundry set or converting a laundry room, this is a two-unit haul that should be quick, affordable, and scheduled within a week of booking.
Electric vs Gas Dryer: The Only Complication
The washer is always standard. Hot water line, cold water line, drain hose, 120V plug. Five minutes to disconnect.
The dryer is either electric or gas:
- Electric dryer: 240V plug (3-prong or 4-prong), a 4-inch flexible metal vent hose clamped to the back, and a vent termination through an exterior wall.
- Gas dryer: A gas flex line, a shutoff valve, and the same vent hose setup. Also has a standard 120V plug for the controls.
Gas dryers require a licensed gas disconnect. Electric dryers can be safely disconnected by the homeowner or the haul crew.
Our how to dispose of old washing machine and how to dispose of a dryer companion articles cover the DIY disconnect steps in detail.
The Removal Process
For the Washer
- Turn off the hot and cold water supply valves behind the machine.
- Disconnect the two water hoses at the machine end. There will be a small amount of water — have a towel ready.
- Pull the drain hose out of the standpipe or utility sink.
- Unplug the 120V cord.
- Slide the machine forward. Two-wheel dolly handles it easily.
For the Electric Dryer
- Breaker off at the panel.
- Unplug the 240V cord (do not pull from the cord — grip the plug body).
- Loosen the clamp on the vent hose, pull the hose off the rear port.
- Slide the dryer forward.
For the Gas Dryer
- Licensed gas contractor or plumber closes the shutoff, bleeds the line, disconnects the flex, and caps the line.
- 120V plug comes out.
- Vent hose comes off.
- Slide forward.
Industry Baseline Range
| Scope | Cost Range | Notes |
|---|---|---|
| Pair haul (both disconnected, accessible) | $125 to $275+ | Two-unit pair rate |
| Single unit (washer or dryer alone) | $85 to $175+ | Single-item pricing |
| Gas disconnect add-on (licensed) | $125 to $275+ | Separate visit for gas dryers |
| Basement or upstairs haul (pair) | $200 to $425+ | Stair surcharge applies |
These figures reflect published industry averages for Oregon metro area removals. Actual pricing depends on disconnect status, access, and whether the dryer is gas or electric.
Current Market Reality
Baseline ranges assume ground-floor laundry rooms with easy-rollout units that are already disconnected. Oregon homes often deviate: second-floor laundry upgrades require carrying heavy units down stairs, stacked washer-dryer combos need lift-and-separate, older front-load washers with concrete counterweights weigh far more than baseline, and gas dryers add the mandatory disconnect visit. Pricing holds up for clean jobs; it drifts up for anything non-standard. See our appliance removal cost guide for neighboring appliance rates.
The Pair Rate Is the Best Value
Almost every Oregon junk removal provider offers a washer-plus-dryer pair rate that is significantly cheaper than two separate single-item bookings. If you only need one unit removed today but know the other is on its way out, consider waiting a few weeks and doing both at once. The second unit adds relatively little labor to a pair haul and the combined invoice is 20 to 40 percent lower than two visits.
Scrap Value
Washers and dryers are largely steel cabinets with copper motors, aluminum pulleys, and some circuit boards. Pair scrap value at Oregon metal yards is in the $30 to $80 range depending on current pricing. This offsets part of the haul fee internally for the provider. Older washers (2005 and earlier) sometimes have heavier counterweights and more recoverable copper, which is why haulers sometimes still take abandoned non-working units at a reasonable rate. The metal scrap value in junk removal article breaks down the full recovery math.
Donation and Resale
A working washer-dryer set under 10 years old is sellable. Oregon secondary-market prices for working pairs run $150 to $500 on Facebook Marketplace or Craigslist. Habitat for Humanity ReStore and local appliance resellers sometimes pick up working units for free in exchange for donation credit.
Conditions for donation:
- Both units must work
- Less than 10 to 15 years old
- No visible damage, no leaks
- All parts attached (hoses, power cords, vent hose)
Dead units or those over 15 years old are usually haul candidates — the resale market has dried up.
Laundry Room Prep
Before the haul crew arrives:
- Clear the path from the laundry room to the truck (hallways, doorways, garage steps).
- Have the water supply valves off and the hoses disconnected if possible.
- Empty the dryer lint trap.
- Verify the electrical breaker is off.
- If gas dryer, have the gas disconnect invoice ready or scheduled for same-day.
A well-prepped laundry room cuts 15 to 30 minutes off the crew's time on site, which matters if your provider charges partially hourly.
Vent Hose and Exterior Termination
The dryer vent hose comes with the dryer. The exterior wall termination (the louvered cap or flap on the siding) stays in place unless you are remodeling the laundry room. Most haulers leave it. If you are closing off the laundry room permanently, a siding contractor can patch the opening.
Frequently Asked Questions
Can you haul only the washer and leave the dryer? Yes. Single-item haul is available, just priced at the single-item rate rather than the pair rate.
What if the washer still has water inside? The hauler will tip it to drain residual water before loading, but if you can run a spin cycle before the appointment and let the drum drain, the mess is smaller.
Does the dryer have to be vented at the time of haul? No. Once it is unplugged and the vent hose is clamped off, it goes on the truck as-is.
How long does a pair haul take? For a disconnected ground-floor set, 20 to 40 minutes of crew time on site.
What about coin-operated units from laundromats? Commercial units are heavier and more expensive to haul. Expect commercial pricing, not residential pair rate.
Scheduling
For a standard washer-dryer pair haul, most Oregon providers offer same-day or next-day availability. Gas dryer disconnect may add a day for the licensed visit. Book both together for the best price. Contact Otesse or review our Otesse junk removal service page to schedule.